HIDROGARNE hydraulic press model with a solid-arch monoblock RM-80 E for stamping

03Dec2013

The hydraulic press HIDROGARNE E model RM- 80 has a power output of 80Tn, belongs to HIDROGARNE R serie and, in this case, it’s optimized for deep drawing or stamping with the following adaptations:

• Hydraulic cushion of 25Tn of power output placed in the bottom table with 12 candles
• Hydraulic ejector of 2Tn with a lift of 25mm in the upper table
• Aproximation speed of 100 mm/sec
• Working speed: 12 mm/sec
• Return speed: 160 mm/sec
• Working press: 235 bar

Its main features are:

• Sturdy construction with closed sides.
• Main Cylinder of single acting with 80 tons includes pre -filled valve.
• 2 side cylinders for approach and quick return.
• Top table with four guides Ø 50 mm with bimetallic antifriction sockets of maintenance free.
• upper and lower tables with machined ” T” slots of M16 x 18
• Hydraulic cushion placed at the lower table with 12 candles Ø 30
• Hydraulic ejector of 2 tons and a stroke of 25 mm placed at the upper table
• Hydraulic unit located on the top rear.
• Electric panel located on the right side.
• Limit switches located on the Left Side
• Three adjustable strokes ending for the upper table, two to adjust the table stroke and one to change the speed.
• Two stroke endings for the cushion, 2 limit switches in the pad, to forward and reverse.
• Pressure switch for end of cycle.
• Selector 1 or 2 speeds.
• Selector for manual or automatic cycle.
• Selector for the annulment of the hydraulic cushion.
• Selector for the annulment of the hydraulic ejector.